Differential curved roller sand making machine

Product Introduction

The differential curved roller sand making machine can be used for crushing operation in artificial stone sand, metallurgy, mineral processing plant, abrasive, chemical plant, water conservancy, power sector and other industries.
Differential surface set roll sand making machine is a simple structure, reliable performance can be fine crushing, ultra-fine crushing operation, can control the fineness modulus of artificial sand making equipment, through the spring fusion hydraulic system more sensitive response, more convenient adjustment, two roller pressure is greater, this product has obtained a number of patent certification, leading industry innovation. Compared with other types of surface matching machine, the area of skin contact material increases, the crushing capacity increases, and the output is higher; The crushing material rotates 360 degrees in two vertical directions, has better grain shape, meets the sand shape standard for sand and stone, and has the advantages of significantly reducing the energy consumption of single motor rotation, reducing the powder content, and longer service life of roll skin. Compared with the same type of single drive roller machine, the output is larger, the grain shape is better, the energy consumption is lower, and the wear is less.

Features & Benefits:

differential
One active wheel and one passive wheel, single motor drive, motor energy consumption is significantly reduced. The formation speed of the two rolls is poor, so that the material forms a material layer, and the material passively forms a 360 degree rotation.

hyperboloid
The material is ground in two 360° states in the crushing chamber. The contact surface of the surface is increased by 30%, so the grain shape is good and the yield is high. Active roll passive roll one wide and one narrow, the full area of the material covering the use of the process can maintain the initial shape of the roller skin for a long time, without secondary processing.

Material layer
After forming the material layer, the material is crushed by lamination. After two 360° extrusion grinding, 80% of the material to achieve stone extrusion, greatly increasing the service life of the roll, powder rate significantly reduced.

Technical parameters